Home About Dorner Distributors TradeshowsSite Map
Dorner Advantage Newsletter

DORNER MFG. CORP.
975 Cottonwood Ave
P.O. Box 20
Hartland, WI 53029 USA

INSIDE THE USA
TEL: 800.397.8664
FAX: 800.369.2440

OUTSIDE THE USA
TEL: 262.367.7600
FAX: 262.367.5827

Home > Standard Products > 6200 Series > Cleated Belt End Drive

6200 SERIES CONVEYORS: Cleated Belt End Drive



Specifications:

  • 11 gauge stainless steel roll formed frame
  • Sealed bearings
  • Belt widths: 1.75” (44) to 12” (305 MM)
  • Conveyor lengths: 2’ (610) to 12’ (3,658 MM)
  • 1.5” (38) bottom of frame to top of belt
  • 12mm diameter integral drive shaft
  • The 1” (25) diameter drive pulley turns approximately
    3.4” (86) of belt per revolution
  • Load capacity up to 80 Lbs* (36 Kg)
  • Belt speeds up to 150 ft/min (46 M/min)
  • Cleats available from .24” (6) to 2.36” (60) high
  • Metric fasteners
  • Mild steel head and tail plates with black nitrite finish
  • Motion sensor switch ready
  • models available

Features/Benefits:

  • Wedge-Lok system for impact protection
  • Streamlined design fits where other conveyors do not
  • Quick 5 minute belt change for increased uptime
  • Low maintenance sealed bearings in both head and tail spindles
  • Lengths in .12” (4) increments
  • Quick clamp rail for easy mounting of bolt-on accessories
  • Rack and pinion design offers fast single point belt tensioning
  • V-Groove frame with guided belt ensures accurate tracking
  • A variety of cleat heights to meet application needs

Wedge-Lok™
System


Change Belts in Less than 5 Minutes!

Loosen fasteners and
collapse tail section.

Remove old belt and replace.

Adjust tension on new belt,
tighten fasteners and go!

 

STANDARD SIZES
Conveyor Width Reference 02 03 04 05 06 08 10 12
Conveyor Belt Width (W) 1.75”
(44)		 2.75”
(70)		 3.75”
(95)		 5”
(127)		 6”
(152)		 8”
(203)		 10”
(254)		 12”
(305 MM)
Conveyor Length Reference 0200 0001 increments up to... 1200
Conveyor Length (L) 2’ (610) .12” (3) increments up to... 12’ (3,658MM)
Note: Lengths 13’ to 18’ available in widths 6” to 18” only.
Cleat types and spacing limited on conveyors longer than 12’ due to belt weight

 

Part Reference Guide (2.90 MB PDF)

Notes:

  • Conveyor load capacity depends on conveyor size, incline, motor position, accumulated loads and other factors. See Performance Charts / Data for details.
  • Order gearmotor mounting packages and gearmotors separately - see Mount Packages and Gearmotors. For support stands and accessories - see Support Stands and Accessories.
  • Dimensions are represented in inches, feet, and (millimeters).
  • Due to the wide variety of drive set-ups and applications, point of installation guarding is the responsibility of the end user.
  • Conveyors longer than 12’ (3658mm) will be constructed using a multiple piece frame. Consult factory for locations of these frame joints. It is recommended that each frame joint be supported by a stand or other means.

 

Back to top