7350 SERIES CONVEYORS: Powered Transfer

1/2” diameter nose rollers for small part transfer
Adjustable height and distance to main roller for fine tuning the product transfer
High speed positive drive conveyor belts to ensure consistent speed
Maintains product speed through transfer for gapping and pacing
Located at drive and/or idler end of main conveyor
Compatible with both curve and straight conveyors
Compatible with all end drive tails and drive mount packages
Made of corrosion resistant materials for wipe down or occasional wash down
Slave driven from main roller for minimal install requirements

Conveyor Width: 4” wide to 36” wide in 2” increments
Conveyor Length: Adds less than 8” to conveyor length
Conveyor Speed: Up to 175 ft/min
Slave Drive Speed Options:
- Same Speed
- Speed Up by 1.6 : 1
- Speed Down by 1.25 : 1

FDA approved 1/2” diameter self lubricated nose bar bushings
Positive drive FDA approved urethane belting
300 series stainless steel / anodized aluminum construction
Plated corrosion resistant bearings
Used on infeed and exit tail
- For infeed tail : Needs conveyor to be ordered with output shaft tail
- For exit tail : Needs conveyor to be ordered with dual output shaft tail
Can be purchased as a conveyor only
- Does not include mounting brackets or slave drive
- Includes output shaft only

Notes:

Dimensions are represented in inches, feet, and (millimeters).
Due to the wide variety of drive set-ups and applications, point of installation guarding is the responsibility of the end user.