GAL-60 Flat Belt Conveyor

The flat belt conveyor GAL-60 allows for a very wide range of uses. It has an extremely rigid frame but at the same time offers a compact size and low weight.

On demand this very versatile model can be made within 24 hours.

The reliable conveyor GAL-60 has a monobloc quality TorsioDur frame. It is available in standard widths between 200 and 800 mm and can be made in any length needed for specific solutions.

Over the whole length of the 60 mm high frame additional accessories can be attached. It is fastened to the frame by sliding blocks with M-8 threads gliding in grooves along the side of the conveyor. By this system the GAL-60 can easily be adapted to various applications. You will find more information on available accessories under the column “Lot of Accessories”.

For a length of up to 1.500 mm and a belt width of up to 400 mm a single column support with aluminium ground plate can be used.

Wider and longer version will require the appropriate amount of aluminium double supports.

Both support systems can be adjusted in height and have a vertical position lock.

Technical Specifications and Accessories

Belt widths:
200, 250, 300, 350, 400, 450, 500, 550, 600, 650, 700, 750 and 800 mm.

Distance between axes / length:
500 to 6,000 mm. All intermediate lengths are possible.

Drive with constant belt speed:
v = approx. 4,6 / 8,5 / 12,8 / 17,1 / 25,6 or 36,6 m/min.
Other belt speeds are possible on request. Connection for 220/240 – 380/415 V, 50 Hz. Protection type IP 54. This drive can be supplied together with a motor protection switch incorporating an emergency off. It has a 2 metre supply cable and CEE plug and is of protection type IP 54.

Drive with infinitely adjustable belt speed:
v = approx. 1,8-6,4 / 3,4-12,0 / 5,1-17,9 / 6,8-23,9 / 10,3-35,9 or 14,6-51,3 m/min.
Other belt speeds are possible on request. The drive is supplied together with a frequency regulator that is ready to be plugged to 240V 50 Hz and has a protection type of IP 65. The frequency controller incorporates a digital motor protection switch.

Geared motor position:
Pulling below the belt or at its side, on the left or right.

Total belt load:
Standard is of 50 kg. Higher loads are possible on request.

GAL-60 Operating Manual