GAL-60-M Flat Belt Conveyor

The GAL-60-M is a flat belt conveyor on which the belt is carried in a trough. Hence, the material that is being conveyed is held in the middle of the belt.

This conveyor is particularly suitable for smaller bulk material.

The GAL-60-M has an extremely rigid TorsioDur frame. On the sides of the frame are profile grooves in which M8 sliding blocks are inserted for attaching accessories. Thus the GAL-60-M can be adapted for various applications.

The model shown in the picture is fitted with a moveable H-shaped support. These supports are suitable for models up to a length of 1,500 mm and a width of 400 mm and even allow a gradient of the conveyor belt order to span slight slopes. Double supports should be used for longer and wider belts.

Technical Specifications and Accessories

Belt widths:
200, 250, 300, 350, 400, 450, 500, 550, 600, 650, 700, 750 and 800 mm.

Distance between axes / length:
500 to 6,000 mm. All intermediate lengths are possible.

Drive with constant belt speed:
v = approx. 4,6 / 8,5 / 12,8 / 17,1 / 25,6 or 36,6 m/min.
Other belt speeds are possible on request. Connection for 220/240 – 380/415 V, 50 Hz. Protection type IP 54. This drive can be supplied together with a motor protection switch incorporating an emergency off. It has a 2 metre supply cable and CEE plug and is of protection type IP 54.

Drive with infinitely adjustable belt speed:
v = approx. 1,8-6,4 / 3,4-12,0 / 5,1-17,9 / 6,8-23,9 / 10,3-35,9 or 14,6-51,3 m/min.
Other belt speeds are possible on request. The drive is supplied together with a frequency regulator that is ready to be plugged to 240V 50 Hz and has a protection type of IP 65. The frequency controller incorporates a digital motor protection switch.

Geared motor position:
Pulling below the belt or at its side, on the left or right.

Total belt load:
Standard is of 50 kg. Higher loads are possible on request.

GAL-60-M Operating Manual