GKAL-60 Inclined Belt Conveyor

The inclined belt conveyor GKAL-60 can be used in wide variety of applications. Upon request it can be made in various sizes within one single day.

The GKAL-60 has an extremely rigid TorsioDur frame in monobloc quality.
As well as in standard sizes it can also be custom made for specific problem solutions.

Along the whole length of the 60 mm high frame, additional accessories can be fixed to M8 sliding blocks gliding in the grooves along the side of the frame.

In a standard configuration the GKAL-60 is equipped with a slatted belt, side guide rails and a receiving hopper with fall black flap. The slats on the belt normally are 20, 30 or 40 mm high. But special heights are also available. The distance between the slats on the belt can be freely chosen. The receiving hopper exists in a small and a big standard version. You will find more information on available accessories under the column “Lot of Accessories”.

The two double supports, with which the GKAL-60 on this page is equipped, can be infinitely adjusted in height and angle. For an easy change of position, the support at the receiving end has little casters. In an alternative configuration the GKAL-60 can have a single column support with wheels.

Technical Specifications and Accessories

Belt widths:
200, 250, 300, 350, 400, 450, 500, 550 and 600 mm.

Distance between axes / length:
500 to 6,000 mm. All intermediate lengths are possible.

Height of bunker back wall:
200, 300 oder 400 mm. Andere Höhen sind möglich.

Drive with constant belt speed:
v = approx. 4,6 / 8,5 / 12,8 / 17,1 / 25,6 or 36,6 m/min.
Other belt speeds are possible on request. Connection for 220/240 – 380/415 V, 50 Hz. Protection type IP 54. This drive can be supplied together with a motor protection switch incorporating an emergency off. It has a 2 metre supply cable and CEE plug and is of protection type IP 54.

Drive with infinitely adjustable belt speed:
v = approx. 1,8-6,4 / 3,4-12,0 / 5,1-17,9 / 6,8-23,9 / 10,3-35,9 or 14,6-51,3 m/min.
Other belt speeds are possible on request. The drive is supplied together with a frequency regulator that is ready to be plugged to 240V 50 Hz and has a protection type of IP 65. The frequency controller incorporates a digital motor protection switch.

Geared motor position:
Pulling at the side of the belt, on the left or right.

Total belt load:
Standard is of 30 kg. Higher loads are possible on request.

GKAL-60 Operating Manual