AM-K Angled Modular Chain Conveyor

The AM-K is a particularly robust flexible belt conveyor.

Its aluminium frame is 95 mm high and provided with groove profiles which can be used for easily attaching any accessories.
As a standard, the belt conveyor AM-K is equipped with a cleated chain made of plastic modules, lateral guide rails and a feeding hopper with a fall-back flap.

The standard height of the side guides is 50 mm, upon request, however, it can also be delivered in other heights.
The length of the horizontal and inclined parts can be adjusted to the individual application. However, a total length of 4 metres should not be exceeded.

From the ground, the angle of inclination of the AM-K can be adjusted in steps of 5° between 40° and 60°.

The cleats may be 1, 2 or 3 inches high and their distance on the conveyor between one another can be freely selected in 1-inch steps. The plastic module chains of the AM-K have been approved by the FDA and are easy to clean. In addition, they are particularly hard-wearing and easy to maintain thanks to the possibility of replacing individual links.

As a standard, the horizontal part is provided with small rollers as support to enable an easy movement of the belt conveyor. A double stand can be inserted in the inclined part, as shown in the figure above. A mobile H-shaped pillar stand can also be used.

Technical Specifications and Accessories

Useable belt widths:
182, 258, 334, 410, 486 and 562 mm. Further widths are available upon request.

Distance between axes A1 horizontal:    500 to 3,500 mm. Any desired lengths are available.

Distance between axes A2 inclined:    500 to 3,500 mm. Any desired lengths are available.

Total length A1 + A2:            at most 4,000 mm.

Drive unit with constant belt speed:
V = approx. 5.6 / 10.4 / 15.6 / 20.8 / 31.2 or 44.6 m/min. Further belt speeds are available upon request. Supply for 220/240 – 380/415 V, 50 Hz. Protection type IP 54.
This drive unit can be delivered ready to be connected including a protective motor switch with an emergency stop and a power line of 2 meters length with a CEE plug. Protection type IP 54.

Drive unit with infinitely adjustable belt speed:
V = approx. 2.2-7.8 / 4.2-14.6 / 6.2-21.8 / 8.3-29.1 / 12.5-43.7 or 17.8-62.4 m/min.
Further belt speeds are available upon request.
The belt is delivered with a connected digital frequency controller, ready to be plugged in for 230 V, 50 Hz. Protection type IP 65.

Geared motor position:
The geared motor can be placed pulling on the left or right side. It can be turned in single steps by 90°.

Total belt load: Standard load 30 kg. Higher loads are available upon request.

AM-K Operating Manual