GF-80-RDG Wire Mesh Conveyor


The flat belt conveyor GF-80-RDG is equipped with a round wire linked belt. It is especially suitable for transporting extremely hot items. Due to its mechanical load capacity offers a good alternative for the transport of sharp-edged metals.

The GF-80-RDG, equipped with our standard linked belt made of stainless steel, is available in widths from 100 – 400 mm and can be delivered within 24 hours.

The frame with a height of 80 mm consists of a quality steel profile with shockresistant two-component coating. Holes with an interval of 30 mm and a diameter of 9 mm serve to mount accessories. Thus, the GF-80-RDG can be adjusted to individual needs.

You will find more information on available accessories under the column “Lot of Accessories”.

With a belt conveyor length of up to 1,500 mm and a width of up to 400 mm, the GF-80-RDG can be used with a pillar stand.
Wider and longer designs of the GF-80-RDG are equipped with the required amount of steel double stands.
All stand systems are adjustable in height and equipped with a vertical position lock.

Technical Specifications and Accessories

Belt width:
100, 200, 300 and 400 mm. Intermediate lengths are possible upon request.

Distance between axes / length:
750 to 6.000 mm. All intermediate lengths are possible.

Drive with constant belt speed:
v = approx. 6.1 / 11.4 / 17.1 / 22.8 / 34.2 or 48.8 m/min.
Other belt speeds are possible on request.
Connection for 220/240 – 380/415 V, 50 Hz. Protection type IP 54.
This drive can be supplied together with a motor protection switch incorporating an emergency
off. It has a 2 metre supply cable and CEE plug and is of protection type IP 54.

Drive with infinitely adjustable belt speed:
v = approx. 2.4-8.5 / 4.6-16.0 / 6.8-23.9 / 9.1-31.9 / 13.7-47.9 or 19.5-68.4 m/min.
Other belt speeds are possible on request.
The drive is supplied together with a frequency regulator that is ready to be plugged
to 230V 50 Hz and has a protection type of IP 65. The frequency controller incorporates a digital
motor protection switch.

Geared motor position: Pulling below the belt or at its side, on the left or right.

Total belt load: Standard is of 50 kg. Higher loads are possible on request.

GF-80-RDG Operating Manual