Drive Modules

Direct Catenary Drive Module

• Lengths:
  • Minimum = 481mm (1.58ft)
  • Maximum = 25 m (95 ft)
  • Minimum tail only (knuckle modules, and plain bend corner) = 329 mm (1.08 ft) (contact factory)
• Drive Sprocket:
  • 65 mm = 16 tooth
  • 105 mm and 150 mm = 12 tooth
• Pitch Diameter:
  • 45 & 65 mm = 129 mm (5.093 in)
  • 85, 180 & 260 mm = 128 mm (5.038 in) 
  • 105 mm and 150 mm = 136 mm (5.336 in)
  • Maximum incline or decline = 7°
• 3/4” and 20 mm Drive Shafts available
• Uses catenary loop for belt take-up
• Side mount sealed gearmotors can be in position 1, 2 or 3
• Optional 20mm diameter x 1.5 in long dual output shaft for common driven conveyors

Direct Guided Profile Drive Module

• For use with gravity takeup or fully contained chain
• Lengths:
  • Minimum = 481mm (1.58ft)
  • Maximum = 25 m (95 ft)
  • Minimum tail only (knuckle modules, and plain bend corner) = 329 mm (1.08 ft) (contact factory)
• Drive Sprocket:
  • 65 mm = 16 tooth
  • 105 mm and 150 mm = 12 tooth
• Pitch Diameter:
  • 45 & 65 mm = 129 mm (5.093 in)
  • 85, 180 & 260 mm = 128 mm (5.038 in) 
  • 105 mm and 150 mm = 136 mm (5.336 in)
    Maximum incline or decline = 7°
• 3/4” and 20 mm Drive Shafts available
• Side mount sealed gearmotors can be in position 1, 2 or 3
• Optional 20mm diameter x 1.5 in long dual output shaft for common driven conveyors
• Optional power transfer available for small part in-line transfer applications

Suspended Drive 

• Lengths:
  • Minimum = 481mm (1.58ft)
  • Maximum = 25 m (95 ft)
  • Minimum tail only (knuckle modules, and plain bend corner) = 329 mm (1.08 ft) (contact factory)
• Drive Sprocket:
  • 65 mm = 16 tooth
  • 105 mm and 150 mm = 12 tooth
• Pitch Diameter:
  • 45 & 65 mm = 129 mm (5.093 in)
  • 85, 180 & 260 mm = 128 mm (5.038 in) 
  • 105 mm and 150 mm = 136 mm (5.336 in)
    Maximum incline or decline = 7°
• 3/4” and 20 mm Drive Shafts available
• Uses catenary loop for belt take-up
• Optional 20mm diameter x 1.5 in long dual output shaft for common driven conveyors

Weighted Take-Up Module

• Provides compact tail for in machine applications
• Lengths:Minimum = 700 mm (27.56 in)
• Uses weighted idler roller and sight gauge for belt take-up
• Take-up module should be located within 2 m (78 in) of discharge end

Please see Engineering Manual for more information